Help! Anyone got any shims? ID 5mm OD 7mm
Posted: Thu Jul 12, 2018 10:46 pm
I have put some new bearings in an old Adcock Stanton and, to get it running perfectly, I need some paper thin brass (?) spacer shims just to lift off the back plate and also at the front, off the bearing. I know this will work and I need paper thin because I made some adhoc, with a hole punch and thick paper, and it worked a treat.
Can anyone help? Ideally I am after four to six shIms in total, although I suspect two may be enough. If needs be I can probably Heath RobInson my own but some real McCoy would be better.
Thanks in anticipation. Tengisgol.
Can anyone help? Ideally I am after four to six shIms in total, although I suspect two may be enough. If needs be I can probably Heath RobInson my own but some real McCoy would be better.
Thanks in anticipation. Tengisgol.