Hello All,
Unfortunately due to my spare funds being somewhat limited for the time being I was thinking about making my own basic landing net handle from some cane ( not split cane). Having had a quick look online I can find some for relatively cheap but I am unsure as to what diameter I would require?
Its going to be used for Cruicians, tench, Perch etc.
Any help would be greatly appreciated thank you.
Regards,
Llyr
Cane landing net handles
- Reedling
- Catfish
- Posts: 5585
- Joined: Fri Mar 01, 2013 11:41 am
- 11
- Location: Kent
Re: Cane landing net handles
Judging by the size of fish (Carp) you caught in your other posting go for one with as long a length as possible, preferably a two section. If the net handle is too short you run the risk of breaking your rods tip section if it makes a final dash as you net it.
- MGs
- Pike
- Posts: 6419
- Joined: Wed Nov 02, 2011 2:24 pm
- 12
- Location: Cornwall
Re: Cane landing net handles
I've made a couple of handles. I find that between 5 and 6 feet long covers most eventualities. It is long enough in most circumstances and at that length, doesn't bend to much. I have fairly small hands so find holding large diameter cane uncomfortable. About 1 inch seems OK. At that diameter it isn't too difficult to insert the required threading.
Old car owners never die....they just rust away
- LlyrEdwards
- Bleak
- Posts: 100
- Joined: Sat Jun 08, 2019 11:06 am
- 4
Re: Cane landing net handles
Thank you all for your help/suggestions