A bit of advice needed chaps

Traditional landing nets large and small.
Post Reply
User avatar
Aitch
Pike
Posts: 6204
Joined: Sat Mar 23, 2013 11:03 am
11
Location: The Shades, Essex

A bit of advice needed chaps

Post by Aitch »

At Redditch I bought a lovely little wooden landing net (albeit with the original knotted mesh) I have swapped the mesh for a rubberised one in the interests of fish safety, but the wood looks tired... so I'm torn between a light sand and buff with beeswax or a light sanding and a couple of coats of varnish...?
Image
Just one more cast love, and I'll be on me way home

Leave nothing but footprints, take nothing but pictures and memories

User avatar
Banksy
Brown Trout
Posts: 1423
Joined: Tue Mar 22, 2016 3:53 pm
8
Location: East Yorkshire

Re: A bit of advice needed chaps

Post by Banksy »

I just give mine a good coat of Danish Oil once a year?
Soaks in nicely, and is developing a nice patina with every application.
I have the same net as you, not sure whether the Danish Oil would affect the rubberised mesh, so I play safe and remove it until the frame is completely dry to the touch.

Jeremy Croxall
Zander
Posts: 3753
Joined: Tue Oct 27, 2015 8:05 am
8
Location: Matlock Derbyshire

Re: A bit of advice needed chaps

Post by Jeremy Croxall »

If it's varnished, strip it and re-varnish, or coat with oil. Although it doesn't look too bad to me so a light sand and new varnish?
I think oiling on bare timber is preferable and easier to maintain in the long run.
"Oh for want of rod and line I'd fish this stream serene, sublime".

User avatar
Banksy
Brown Trout
Posts: 1423
Joined: Tue Mar 22, 2016 3:53 pm
8
Location: East Yorkshire

Re: A bit of advice needed chaps

Post by Banksy »

Image

User avatar
Old Man River
Eel
Posts: 2173
Joined: Wed Nov 25, 2015 3:43 pm
8
Location: Yorkshire

Re: A bit of advice needed chaps

Post by Old Man River »

Certainly Danish Oil is the way forward,I finish all
My bentwood net frames with Danish oil. It does not chip, the wood absorbs the oil which acts as a preservative, multiple coats give a lovely patina, which can be resurrected easily if and when the frame gets a bit of a
“ well used “ look by simply re applying a few further coats of oil.

I simply give the whole frame a wipe over with a rag soaked in the oil, leave to dry, usually about an hour or so, then buff up the frame with a soft cloth, leave to harden off for 12 hrs , give a further buff up and do the same again as many times as you think fit. Soon you will have built up a hardwearing patina that is better than any yacht varnish finish and so much easier to bring back to good condition without any sanding back etc.
If you are so inclined after sanding the varnish back you could stain the frame any colour of your choice defore applying the oil, use spirit stain as it gives a better colour with more depth .

Image

Image

Here is one of my frames stained with mahogany and finished with Danish Oil .

David
Hurrumph....... whatever happened to Handlines ?

User avatar
Old Man River
Eel
Posts: 2173
Joined: Wed Nov 25, 2015 3:43 pm
8
Location: Yorkshire

Re: A bit of advice needed chaps

Post by Old Man River »

Banksy wrote: Fri Dec 08, 2023 4:15 pm Image
Seem to recognise that David. :Hat:

David
Hurrumph....... whatever happened to Handlines ?

User avatar
Aitch
Pike
Posts: 6204
Joined: Sat Mar 23, 2013 11:03 am
11
Location: The Shades, Essex

Re: A bit of advice needed chaps

Post by Aitch »

Thank you Gentlemen... I shall try the Danish Oil treatment


David (OMR) I think I bought the head from your stand at Redditch (at least there was a lot of Old Man River signage and cards on the table...
Just one more cast love, and I'll be on me way home

Leave nothing but footprints, take nothing but pictures and memories

User avatar
Old Man River
Eel
Posts: 2173
Joined: Wed Nov 25, 2015 3:43 pm
8
Location: Yorkshire

Re: A bit of advice needed chaps

Post by Old Man River »

Aitch wrote: Fri Dec 08, 2023 4:33 pm Thank you Gentlemen... I shall try the Danish Oil treatment


David (OMR) I think I bought the head from your stand at Redditch (at least there was a lot of Old Man River signage and cards on the table...
Sorry Aitch, it is not one of my frames,your frame has a brass spreader, mine are alloy . If it had been one of mine it would have already been finished with oil.

David
Hurrumph....... whatever happened to Handlines ?

User avatar
Aitch
Pike
Posts: 6204
Joined: Sat Mar 23, 2013 11:03 am
11
Location: The Shades, Essex

Re: A bit of advice needed chaps

Post by Aitch »

Oh well... sorry for the confusion David... but its a nice net head and will be fine for my Roach and Perch fishing.. be even better once its had a coat or three of oil... :Hat:
Just one more cast love, and I'll be on me way home

Leave nothing but footprints, take nothing but pictures and memories

Post Reply

Return to “Traditional Landing Nets”