Bamboo Two Part Landing Net Pole.
Posted: Wed Oct 25, 2023 3:27 pm
I have recently made a two part landing net pole from an old sea fishing rod... stiff as a poker!
Each section is 43 inches long or there abouts.
I had an old brass treaded end section from and old bamboo pole handle that fitted the end of this one nicely.
I rubbed it down, did a minimal amount of whipping ( leaving the original green on because it was solid) then gave it a few coats of exterior yacht to varnish ( it dose what is says on the tin)
Its a good solid pole/ handle.
What would be the best finish on the end???
I have lots of bits of wood knocking about, I was thinking of whittling out some kind of bung like you put in the end of a rod, its to nice to put a rubber end cap on it.
Mr B
Each section is 43 inches long or there abouts.
I had an old brass treaded end section from and old bamboo pole handle that fitted the end of this one nicely.
I rubbed it down, did a minimal amount of whipping ( leaving the original green on because it was solid) then gave it a few coats of exterior yacht to varnish ( it dose what is says on the tin)
Its a good solid pole/ handle.
What would be the best finish on the end???
I have lots of bits of wood knocking about, I was thinking of whittling out some kind of bung like you put in the end of a rod, its to nice to put a rubber end cap on it.
Mr B